VisualMill Technical for Techno TC CNC

[Kevin Waldron]

I have just purchased Rhinoceros and Visualmill-Rhinocam 5-6 for a Techno PC w/tool changer and was hoping that someone has all the info available to setup the post processor(I do have have a fourth axis rotary head and I will be using an aggregate head on the tool changer. I have 13 active tools on changer). I have Enroute and Artcam (these programs would not directly support the 4th axis nor the aggregate head thus the purchase of VisualMill)but have never had to answer all the questions that VM ask. It would make my life easier if someone could share and or fax / e-mail these settup answers for this particular machine. I am new at CNC and often I don't even know what the question is asking.

Thanks for any help,

Kevin

[Chazzny4]

Hi Kevin,

I can guide you through whatever issues you are having with Visual Mill. Also, it has been reported that Enroute4, either in release or to be released any day has the 4th aix support you are looking for.

Regards,

Charlie