VM 3.0 Post Processor for Mach 3 OR 2 - CNCzone.com-The Largest Machinist Community on the net!

TCSpooner · #1 04-14-2007, 04:10 PM

Hi I'm using VM 3.0 which I recieved with my copy of Alibre. I'm looking for a processor for Mach 3 or 2. I obviously can use another processor but I'm fussy and would like the correct one if it's available. Any help would be much appreciated.

RandK · #2 04-14-2007, 10:05 PM

Try http://www.mecsoft.com/Mec/Downloads/posts.shtml

TCSpooner · #3 04-15-2007, 09:12 PM

I did and it works a charm. Thanks

dgalaxy · #4 12-25-2007, 01:35 PM

Do you like that alibre with v3.0- i was debating on alibre expert or visual mill 6.0 basic i really dont need a solid model right now but i would like something i can grow into . i have sheetcam right now just would like your opinion (Looking for something to replace my bobcad v22 i just bailed)

John

TCSpooner · #5 12-27-2007, 09:55 PM

Hi

I like it just fine you need to keep things in perspective though it's no master cam that's for sure

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
post processor for mach 3?	njitnjau	EdgeCam	12	11-23-2010 08:10 PM
Post Processor	scubanick	Surfcam	16	01-31-2010 10:05 AM
Post processor info for Mastercam to Mach 3	9lrac9	Post Processor Files	7	08-10-2009 08:08 PM
Mach post processor for Artcam	mikie	Mach Software (ArtSoft software)	6	11-15-2005 08:22 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)