Wondering who on here uses VisuallTurn and how you like it if you do. I have played with the demo a little but to be honest I'm not sure if I care for the GUI when compared to VisualMill 6.0. I remember looking at it a couple years ago was told by a salesman that VTurn 2.0 would be out in the fall of that year, but I haven't heard anymore. Is there any plans to update this?
Thanks for your input.
I looked at it couple years ago for some really complicated processing.
Either it wouldn't do what I needed or I couldn't figure it out (don't remember).
Either way that was as far as I went with it. I have a FAGOR conversational control and do all programming on the machine. The nasty part that I wanted to do with VT probably took an extra week without high end CAM, but I have never needed/wanted turning CAM since that day.
I have been using VM Pro since 04.