Parameter Bank Select Viper 95

[cnc_oz]

Hi Larry,
Manual V2.0.1 shows the Parameter Bank Select jumpers (Page 32).
What I cannot find is which end of the plug I should count from.
ie Is the reverse motor jumper nearest the board edge or opposite edge.
I dont see any printed info on the PCB itself.

I dont want to stick jumpers on to find out I have counted from the wrong end.

Thanks
John

[Larken]

The bottom of the board is there the motor connectors are. (The encoder and motor output)

The top is the 5pin programming connector. The reverse jumper is at the top.

Larry

[cnc_oz]

Thanks,
I will mark my manual appropriately.

Regards
John