- Trying to get the Viper BX7 to work
-
Registered
Trying to get the Viper BX7 to work
Hello all! trying to get the breakout board BX7 to work with a VFD, Just cannot figure it out? upon sending the command from Mach say S1000 =10v is OK and S500=5v ETC..Fine, but trying to turn on and off a 12v relay is a NO GO! Anyone have a BX7 with any success? Any help is greatly appreciated.
Thanks
Similar Threads:
-
-
Member
Re: Trying to get the Viper BX7 to work
Send me your XML file and i will take a look at it.
Larry
- Trying to get the Viper BX7 to work
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules