bad link
https://youtu.be/BSqfchqx1c8
http://https://youtu.be/BSqfchqx1c8
I had been wanting to clean up my wires and I hate zip ties, so here was my solution.
Similar Threads:
- Anilam 3000MK - servos won't come on, loose cable w/wires at end = missing estop btn?
- Upgraded 5 Axis CNC Breakout Board + DB25 Cable + 5V USB Cable + Mach3 Software
- Cable carrier competition: The way you use your cable carriers could earn you a cash
- Longer parallel cable or longer steper wires?
- Cleaning up a cable mess
bad link
https://youtu.be/BSqfchqx1c8
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Don't have time to watch it right now, but have seen similar videos for cleaning up wiring in PC's. A little advice. Turn your camera sideways when shooting video.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
I figured you would catch that. This was video number two, and my buddy had mentioned the same thing. So I'm trying to keep it landscape from here on out.