Gorton 2-30 ready for CNC project

[paulmars]

Its for sale. $1800 and it works fine. Buy and convert it.

pa

[SpeedsCustom]

Where are you located?

-Jason

[paulmars]

Where are you located?

-Jason

st pete florida.

[SpeedsCustom]

Oh! I wonder how much freight would be!


-Jason

[paulmars]

Oh! I wonder how much freight would be!


-Jason

dont know. to where? Come pick it up.

pa

[SpeedsCustom]

I'm in New Jersey ....


How is the condition? How many hours etc...Have any pictures?


-Jason

[paulmars]

I'm in New Jersey ....


How is the condition? How many hours etc...Have any pictures?


-Jason

Good working condition. Used by one operator since new. Well maintained. I can e mail pictures.

[JerkyBoy]

Speed Custom,

The Gorton is probably 40 years old, so it might have 160,000 hours on it.

You could put it in your toy room, it weighs around 4000 lbs

http://www.dogpatch.com/bobp/shop/gorton.jpg

After you finish your Taig project, you will be ready for a real challenge.

JerkyBoy

[SpeedsCustom]

Ha! That thing is huge!

Paul- I'll pm you.


-Jason

[paulmars]

Speed Custom,

The Gorton is probably 40 years old, so it might have 160,000 hours on it.

You could put it in your toy room, it weighs around 4000 lbs

http://www.dogpatch.com/bobp/shop/gorton.jpg

After you finish your Taig project, you will be ready for a real challenge.

JerkyBoy

Its old, but not that old. Our looks newer then that one.

[JerkyBoy]

Since the last year one was produced was around 1976 I stand corrected.

It might be only 32 years old.

See attached link for serial numbers and year produced.

http://gorton-machine.org:8080/machines/serialnum.html

JerkyBoy

[paulmars]

Since the last year one was produced was around 1976 I stand corrected.

It might be only 32 years old.

See attached link for serial numbers and year produced.

http://gorton-machine.org:8080/machines/serialnum.html

JerkyBoy

Been there and ours is not listed. 46938. Already talked with Rick Gorton (site owner and great grandson).