Help need info on postprocessors

[Toolbit]

I have an Anilam 1100 control and can't seem to be able to find any reference of a postprocessor for it. Does Vectric furnish a postprocessor for the machines after the software is purchased? I thought this software rocked a couple of years ago when I looked at it but didn't want to have to convert the Vectric output to conversational format in order to use it. I thought that there might be some postprocessors listed by now that could be used but I didn't find one listed.

[thkoutsidthebox]

Hi Toolbit. I agree, the Vectric software does rock! Have you tried e-mailing Vectric? I'm sure the guys there will let you know straight away. I usually get an email reply the same day, even on weekends! support@vectric.com

[Switcher]

They already have 2 PP for Anilam, mm/inch.

Look inside the (VCarve Pro 4.6 Trial\PostP) folder (arrange the icons by Name), it will by the first 2 on the list. It's a simple text (.txt) file, that can be openend in Win. Notepad.

It should also show up when you open the Trial Version of both VCarve Pro 4.6 & 4.5. It's also in Cut3D.

I'm not sure If you'll need anything special for that version of the control (Anilam 1100)?

If that don't work, do like thkoutsidthebox suggested & send Tony at Vectric an email, or keep this thread active.

.

[Toolbit]

Thanks for the suggestions it's been a couple of years since I had down loaded a Demo at which time there were no postprocessors. I'll go and download a recent version and see what the Anilam postprocessor looks like.

CNCZONE rocks a bunch of great people here at the zone.

[Switcher]

Vectric has come a long way in the last couple of years, back then I think it was called Vcarve Wizard, they have added lots of features.

They now have 169 PP in the Vcarve 4.6 Trial version.

.