Mach2/3 & TurboCNC Postp's

[Tony Mac]

New postprocessors are now available for Mach2/3 & TurboCNC and they work with both the Full customer release and the Free Trial Version.

You can download the files and (very simple) installation notes from the link below,

http://www.vectric.com/vectric/image...ostp/index.htm

Remember that you can actually cut the Sample designs using the Free Trial Version of VCW.

If you need assistance installing a postprocessor or have any associated questions, please email us at support@vectric.com

Regards,
Tony Mac

[Mac T. Knife]

I've bought the program, and I use Mach 3, and downloaded the postprocessor, However, when I try to save multiple toolpaths, I get a message that mill program can't handle toolchanges!!! Granted I don't have a toolchanger,,,(cept me) but Mach does have an option to stop the machine for a toolchange until you hit start again,,,, Sheetcam, and Meshcam both allow this.

[southernexplore]

I had the Vectric team make a Postprocessor for the same reason. At the end of each tool it just calls up an M0 and stops, I make the changes and then hit the cycle start again. Works perfect but you must set the new "Z" before starting.
I will post it if I can. It will not let me so I would have to do it by email. Send me your email address and I can shoot it to you. Just read between the lines for my address.
Tony may get to this before you read my post though. He was very helpful with me.
Tommy C.

****southern****explorer@****charter****.net

[Tony Mac]

Thanks Tommy for your help with this postop issue.

Hi Mac T. Knife,

If you still need assistance please send an e-mail to support@vectric.com and we will send you a newer postp and installation notes.

Tony

[Mac T. Knife]

Thanks, will do.

[timmyb199]

tried downloading the file and canty open it, what should i do now?? i left click a page opens showing everythign but i dont know what to do with it(like a word file or something) if i save it to disk i cant open it period

[Tony Mac]

Timmyb199,

Please e-mail us at support@vectric.com with details of the controller / machine you are running and we will get back to you.

Tony

[secas]

I would like the post processor for turbocnc if possible.
Thank you,
Shane

[Tony Mac]

Hello Sane,

Please e-mail us at support@vectric.com with details of the controller / machine you are running and we will send you the appropriate postp.

Tony