- Engraving bit vcarve
-
Member
Engraving bit vcarve
Hi
Does anyone have a good tool database for vcarve?
Im pretty new and i want to buy this:0.1mm 15 Degree Titanium Coated Carbide Flat Bottom PCB Engraving Bit CNC Router | eBay
but i dont have a clue abotu settings such as plunge rate etc.
hope someone can help
Similar Threads:
-
-
Registered
I don't have the answer but I can suggest posting your request on the Inventables XCarve forum. I read it frequently and the folks there are quite knowledgeable and very helpful. Also please note that based on what I've read, it is critical that your PCB is perfectly level or that you run an auto level macro to compensate for any misalignment. I use UCCNC to control my DIY CNC router and there is an interesting YouTube video about an auto level plugin for that software. Search YouTube for UCCNC PCB Autoleveler Plugin to see how it's done.
-
Registered
I don't have the answer but I can suggest posting your request on the Inventables XCarve forum. I read it frequently and the folks there are quite knowledgeable and very helpful. Also please note that based on what I've read, it is critical that your PCB is perfectly level or that you run an auto level macro to compensate for any misalignment. I use UCCNC to control my DIY CNC router and there is an interesting YouTube video about an auto level plugin for that software. Search YouTube for UCCNC PCB Autoleveler Plugin to see how it's done.
- Engraving bit vcarve
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules