- Vacuum Forming Rise Profile
-
Registered
Vacuum Forming Rise Profile
I am new to vacuum forming technology. I am planning to make around 50 of 20" x 20" x 3.5" square bucket. The bottom of the bucket I like to have some pattern like square or diamond dots like the attached pictures.
Will I get this type definition for the diamond pattern. If I am using around 2mm thick ABS sheets. The diamond pattern is around 1/2" x 5/8" and the textures are from the original sheet of the ABS.
Thanks
Similar Threads:
Last edited by Mcyoda; 11-15-2010 at 10:36 PM.
-
- Vacuum Forming Rise Profile
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules