Vacuum Forming Rise Profile

Results 1 to 1 of 1

Thread: Vacuum Forming Rise Profile

  1. #1
    Registered
    Join Date
    Jul 2008
    Location
    USA
    Posts
    68
    Downloads
    0
    Uploads
    0

    Default Vacuum Forming Rise Profile

    I am new to vacuum forming technology. I am planning to make around 50 of 20" x 20" x 3.5" square bucket. The bottom of the bucket I like to have some pattern like square or diamond dots like the attached pictures.

    Will I get this type definition for the diamond pattern. If I am using around 2mm thick ABS sheets. The diamond pattern is around 1/2" x 5/8" and the textures are from the original sheet of the ABS.

    Thanks

    Similar Threads:
    Last edited by Mcyoda; 11-15-2010 at 10:36 PM.


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Vacuum Forming Rise Profile

Vacuum Forming Rise Profile