UC100 Issues

Results 1 to 2 of 2

Thread: UC100 Issues

  1. #1
    Member
    Join Date
    Mar 2010
    Location
    usa
    Posts
    68
    Downloads
    0
    Uploads
    0

    Default UC100 Issues

    I went from DB25 to usb via the UC100. I think I have driver issues. Everything works as it should ecept the spindle doesnt turn on and my home switches dont work. I reloaded the UC100 drivers and it acted different but still not right. I have a Windows 8 64bit pc with CandCNC electronics. I cant seem to find much support on these UC100 controls.Any suggestions? Thanks

    Similar Threads:


  2. #2
    Member ger21's Avatar
    Join Date
    Mar 2003
    Location
    Shelby Township
    Posts
    35538
    Downloads
    1
    Uploads
    0

    Default Re: UC100 Issues

    If everything else works, the problem is likely your software settings. Are you using Mach3? If so, you might want to try setting up a new profile from scratch.
    CNC Drive, the manufacturers of the UC100, have very good support. You could try emailing them.

    Gerry

    UCCNC 2017 Screenset
    [URL]http://www.thecncwoodworker.com/2017.html[/URL]

    Mach3 2010 Screenset
    [URL]http://www.thecncwoodworker.com/2010.html[/URL]

    JointCAM - CNC Dovetails & Box Joints
    [URL]http://www.g-forcecnc.com/jointcam.html[/URL]

    (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

UC100 Issues

UC100 Issues