Cross Slide Vise Recommendation

[edge]

I'd like to get a recommendation for a medium quality 5" cross slide vise to use with my drill press for about $ 100. Most of the Asian units I've seen are low quality with a lot of back-lash in the slide advances. The vise should have about a 6 " throat opening, long. travel of 6", a cross travel of 5" and the re-zeroing dials on the advances graduated in .001".


Thanks

Similar Threads:

• DIY Cross slide indicator.
• cross slide crabing
• Cross Slide Vise Advise Needed
• Metal for cross slide
• cross slide

[NeoMoses]

Unfortunately, I havent' seen many good cross slide vises. All that I've seen are cheap (but not necessarily inexpensive).

You might do well to buy a good X-Y table with T-Slots and attach a good drill-press vise to it.

[edge]

Any recommendation on a source for an x-y table?

[cncadmin]

Little machine shop has China made X,Y tables.

[Klox]

Edge,
go check out www.knuth.de they have what they call "compound sliding tables". Sorry i don't have the faintest idea on prices....
Hope this will point you in the desired direction.

Klox