Hello everyone,

I'm new to this forum and new to programming. I've taken over doing programming for our OLD Amada Pega machine using FabriWIN 2014.

This is a very old machine without indexable (indexible?) tooling. So the setup sheet from the NC file has the tool angles listed in it. The operator then sets the tools at the an angle indicated on the setup sheet. But the operator is telling me that for angles other than zero or 90, I need to change the angle from what FabriWIN generates. For example, we had one today where FabriWIN's .NC file called for an angle of 120°. The operator said he had to put the tool in at 150° for it to punch right.

Is this something I can correct in the settings in FabriWIN? I admit to not fully understanding the problem, yet. But I'm hoping someone else has seen the problem and can comment.

Thanks,
Bill

Similar Threads: