I need a bit of guidance on getting some CAM software and three accompanying custom posts. I've been in touch with my MasterCAM dealer but the end price is too expensive for us ($12,000). We're ideally looking to spend $7500 on everything (CAM and posts).
We're running old machines: Busellato Jet 4002 with an AlBNT numerical controller, a Triax with a Fanuc controller, and a CMS nameless thing from 1997 with an OSAI series 10 controller. The Busellato uses Genesis for programming, the Triax uses CMS WinTools, and the unnamed CMS uses hand-programming. The Triax and CMS will at least need block drilling cycles too.
I need some direction on CAM software where you know of a company that will make custom posts for these machines.