Results 1 to 3 of 3

Thread: The UHU wiki, questions and improvement.

  1. #1
    Registered
    Join Date
    Dec 2005
    Location
    netherlands
    Posts
    303
    Downloads
    0
    Uploads
    0

    The UHU wiki, questions and improvement.

    The UHU Wiki.

    Often information about the UHU is spread over many messages.
    Sometimes the info is hard to find.

    The UHU wiki is a attempt to gather useful information about the UHU servo controller and present it in a easier to find way.
    http://gsst.wikispaces.com/

    Feel free to add useful information to the UHU wiki.
    Small or big contributions are all welcome.

    If you have never contributed to a wiki, it is easy.
    Here is a tutorial, you get this page if you click on 'help' in the right upper corner.
    http://sandbox.wikispaces.com/search/view/tutor

    You can practice in the sandbox.
    You can mess about, experiment, make mistakes as much as you want :-)
    http://sandbox.wikispaces.com/

    To figure out what information to add to the UHU wiki and where to put it can be a bit more difficult :-)

    Vroemm.


  2. #2
    Registered
    Join Date
    Dec 2005
    Location
    netherlands
    Posts
    303
    Downloads
    0
    Uploads
    0
    Hi.

    I have added a link to the Regenerative Power Dump Circuit to the UHU wiki.
    See bottom of the page.
    http://gsst.wikispaces.com/UHUpowersupply


  3. #3
    Registered
    Join Date
    Jan 2005
    Location
    India
    Posts
    1,056
    Downloads
    0
    Uploads
    0
    vroemm,
    its better to add the data than just a link to it, that way we have two sources of data - just in case if one is lost we have the other -


Similar Threads

  1. The UHU parts list, questions and improvement.
    By vroemm in forum UHU Servo Controllers
    Replies: 17
    Last Post: 09-01-2008, 11:20 AM
  2. Which machine for process improvement?
    By RoboElvis in forum General Waterjet
    Replies: 0
    Last Post: 02-05-2008, 09:47 AM
  3. Z improvement, Aaron, anyone
    By ozzie34231 in forum Industrial Hobbies (Support forum)
    Replies: 3
    Last Post: 04-22-2006, 09:00 PM
  4. Need a Wiki!
    By Chagrin in forum Suggestions for the CNCzone.com site.
    Replies: 3
    Last Post: 07-22-2004, 12:38 AM
  5. Sugested improvement
    By pminmo in forum Suggestions for the CNCzone.com site.
    Replies: 8
    Last Post: 07-09-2004, 08:43 PM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.