Newbie- NX4 Newbie

[ou812]

Hi all,

I just stated using NX4. I'm a long time Mastecam user and hoping I can find a few of the long time NX users here willing to help. I'm currently going thru CAST and finding it leaves a bit to be desired for me. I have the basic drawing down, but getting the stock/part set-up on the manufacturing side sems to be a pain in the, you know what.

Anyone one have any suggestions beyond a actual training class? We are looking a to whats available for classes too.

ou812

[weirdharold]

This is good training for NX. Have been using it for almost a year now. http://www.myigetit.com


Regards,
Harold C.

[pednekar]

hi friends,
this is sanjay from india, anybody can give me ugNX-4 cad/cam tutorial.

[cyrus2000]

Originally Posted by ou812 Hi all, I just stated using NX4. I'm a long time Mastecam user and hoping I can find a few of the long time NX users here willing to help. I'm currently going thru CAST and finding it leaves a bit to be desired for me. I have the basic drawing down, but getting the stock/part set-up on the manufacturing side sems to be a pain in the, you know what. Anyone one have any suggestions beyond a actual training class? We are looking a to whats available for classes too. ou812

NX CAM is easier than MC ,but be care about cutter jump
Some tips here:
For roughing strategy and subroughing strategy -use Cavety Mill only.
For finishing strategy -use ZLEVEL_PROFILE,or FIXED_CONTOUR.

[mill_man]

We started using i get it a while ago and the cam training is great http://www.myigetit.com

[pednekar]

hi,thanks for ur valuable reply

[maw77]

Originally Posted by weirdharold This is good training for NX. Have been using it for almost a year now. http://www.myigetit.com Regards, Harold C.

Thanks for the tip weirdharold. I'll give http://www.myigetit.com a try.