| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| UG NX UG CAD/CAM Discussion |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-11-2009, 06:58 AM
| |||
| |||
All you might be knowing that ugpost can be run outside of NX session thru ugpost. But there is a very little help available about this module in the help section. All I tried and figured out was ...yes it does output a single .nc file for me. What if i have 5 operations and i want 5 different nc files? is ugpost is capable of doing it? and what about the naming rules applied in this operation.
__________________ Ananth Kulkarni THE GREATEST OAK WAS ONCE A NUT WHO HELD ITS GROUND    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Help!- CCS for windows, please. | samaniegoh | Controller & Computer Solutions | 1 | 04-12-2010 12:53 AM |
| DX/32 in Windows XP... | albion | Bridgeport and Hardinge Mills | 2 | 10-26-2008 08:48 AM |
| Windows XP | larry53 | Computers and Networking | 13 | 01-31-2008 08:48 AM |
| windows dro | the4thseal | General Electronics Discussion | 10 | 06-10-2007 07:28 PM |
| Windows XP or Windows 2000 better with Mach2 | Beezer | Mach Software (ArtSoft software) | 2 | 10-18-2004 11:08 AM |
| | |
Linear Mode
