Need Help! form tool in VA program - NX8 - CNCzone.com-The Largest Machinist Community on the net!

mathisudar · #1 01-31-2012, 03:19 AM

Hi,

Please let me know,how to use FORM cutter in variable axis programming(NX8).

regards,

MATHI K

camster · #2 02-01-2012, 11:16 AM

Form tools , User defined tools, are only availabel for use in Planar Profile operations. For Variable contour you ccan use 3,4,5 parameter end mills, ball mills and T-cutters

mathisudar · #3 02-01-2012, 10:30 PM

THANKS

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- Move G54 form program	briker	G-Code Programing	2	04-20-2010 10:29 AM
Build Thread- Thread cutting tool form	leeharrysouth	General Metalwork Discussion	9	12-05-2008 04:07 PM
Does V20 program tool tip or tool center	Pat	BobCad-Cam	3	06-17-2005 05:46 PM
form tool for cotter pin	pyroracing85	General Metalwork Discussion	2	02-21-2005 11:31 AM
How do you setup a form tool in GibbsCam with a non-cutting (red) area?	DigitalDeath	GibbsCAM	3	12-19-2004 05:43 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)