Need Help!- post processor for mazak

[ab24]

Anyone out there that can direct me where to get a post for NX6 for a mazak?

[1 Infinite Loop]

I would check the Siemens support site downloads section. There are free posts for many different machines. You can navigate to it through the Siemens PLM Automation site or if you prefer ftp you can go to ftp.ugs.com; current support is required.

[ab24]

I have looked but they do not have any with sub-spindle and y-axis. I really do not want to spend an extra 11k dollars for mazacam software. I find this all hard to believe that this is not out there.

[1 Infinite Loop]

Perhaps wait a while and see if anyone replies before you pay for a post but that may be your solution. IMO it would be better to pay for a NX post than to buy the Mazak software and fragment your workflow.

[NX Automation]

Hi, I have worked for Mazak for many years as a project engineer, and I have developed most postprocessors for Mazak machines, Such as Mazak e1060v e800v, EH650, VariAxis 500, Integrex 200, MM2000, VM410/510, etc. The difficult point is the G68/G68.5 for Coordinate system rotation, and G43.4 for tool tip compensation....

If you need any Mazak post or any other kinds of post, please contact me. I have developed all kinds of postprocessors while I was working for a UGS distributor...

My contact: support@nxcadcam.com
website: NX CAD CAM* Automation**Service*** - NX CAD CAM Automation Home