Sketching over a import .tiff file - CNCzone.com-The Largest Machinist Community on the net!

camtd · #1 09-21-2011, 10:31 AM

I there a way to import a .tiff or bitmap file to sketch over. I am using NX 7.5

Thank You

VTBromley · #2 01-06-2012, 09:54 AM

Yes under the menus go to: View -> Visualization -> Raster Image. There you should be able to place a .tiff image on a plane.

Good Luck!

camtd · #3 01-20-2012, 10:44 AM

Thank You, that worked good. I did notice when I tried to rotate the .tiff image
in UG the .tiff file image disappeared. Does that usually happen?

VTBromley · #4 01-20-2012, 12:10 PM

No it shouldnt.. Make sure you are in studio view. I believe the tiff image only appears with that setting.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)