I use turbocnc 4.0 to control my 2D mill for a while.
The turbocnc works perfect with my mill,
but my mill is just 2D (X.Y), I have to stay in mill for one G-code loop be done and need to get Z axis downward by manual.
Sometimes, I need to leave the machine for a while, but the spindle still runs when g-code loop get finished, I think I need a relay circuit for turbocnc to control the spindle ON/OFF,
Does anyone has experiences or resource about my problem?
Thanks for any reply.
Mach3 2010 Screenset
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Thank you, Gerry.
That is a great solution for me.
Maybe I will add a coolant control unit for for my mill.