How to set a relay for a spindle motor ON/OFF control - CNCzone.com-The Largest Machinist Community on the net!

TTaki · #1 03-06-2005, 12:44 PM

hi,everyone
I use turbocnc 4.0 to control my 2D mill for a while.
The turbocnc works perfect with my mill,
but my mill is just 2D (X.Y), I have to stay in mill for one G-code loop be done and need to get Z axis downward by manual.
Sometimes, I need to leave the machine for a while, but the spindle still runs when g-code loop get finished, I think I need a relay circuit for turbocnc to control the spindle ON/OFF,
Does anyone has experiences or resource about my problem?
Thanks for any reply.

TTaki

ger21 · #2 03-06-2005, 12:56 PM

Tutorial for Spindle Control

TTaki · #3 03-09-2005, 07:26 AM

Thank you, Gerry.
That is a great solution for me.
Maybe I will add a coolant control unit for for my mill.

Best Regards,
TTaki.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
CNC Controlled Spindle motor speed control	gregmary	General Electronics Discussion	13	02-27-2009 08:01 PM
Parallel Port / Relay Control Question	Verboten	Computers and Networking	7	12-21-2004 05:17 PM
E-Stop Hard Wire and to Software?	Sanghera	General Electronics Discussion	20	10-30-2004 12:22 AM
HobbyCNC controller spindle control?	PranksterO	General Electronics Discussion	6	07-26-2004 07:40 PM
Relay for spindle on/off	yukonho	Xylotex	14	03-30-2004 11:50 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)