| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| TurboCNC Discuss TurboCNC controller software here! |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#14
 
01-17-2007, 09:47 PM
| |||
| |||
| look in your local paper for free treadmills, most have a 1/2-3/4 hp 90V DC motor with the speed controler. some have a HUGE steel flywheel mounted to the shaft, Keep it and just mount a pully on the end of it. they run VARY smooth  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Sweo spindle drive? new mill dead spindle | Shizzlemah | Fadal | 13 | 12-18-2008 11:11 AM |
| GE spindle drive | 69owb | General Electronics Discussion | 6 | 03-20-2008 12:27 PM |
| Direct drive with stepper on rack and pinion. | jerryrigge | Linear and Rotary Motion | 24 | 10-09-2007 09:21 PM |
| spindle drive | mark c | General Electronics Discussion | 10 | 04-12-2005 09:53 PM |
| Need a low cost 4 amp, 48 volt, stepper drive | Mini Miller | Stepper Motors and Drives | 19 | 12-15-2004 01:29 PM |
| | |
Linear Mode
