| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| TurboCNC Discuss TurboCNC controller software here! |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
02-16-2005, 03:48 PM
| ||||
| ||||
Its my understanding that turbocnc can control your motors without any controllor boards or anything, straight connect to your motors. Anyone know of this or have links that can explain? Al i have found here in search and reading is that is it explained on their website, but i could not find where it is at all, and i think i clicked every link on that site. thanks, Joe    |
|
#2
02-16-2005, 04:57 PM
| ||||
| ||||
| You can't run steppers directly from the parallel port. But, there was some discussion of this about a week ago on the DIY CNC group @ Yahoo groups. You might want to join the group and read through the messages from the last 2 weeks.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Parrallel Port wiring | xairflyer | General Electronics Discussion | 18 | 01-31-2005 08:05 PM |
| Parallel Port Options | JasonCroyle | General Electronics Discussion | 4 | 01-12-2005 08:23 AM |
| Parallel Port | Shanghyd | Computers and Networking | 1 | 11-22-2004 12:56 PM |
| Driving Parrallel Port | JOE65 | Mastercam | 0 | 03-22-2004 12:16 PM |
| Using A Laptop Without Serial Port | mtech | Computers and Networking | 6 | 08-17-2003 09:58 AM |
| | |
Linear Mode
