Results 1 to 3 of 3

Thread: Feedrate Override

  1. #1
    Gold Member
    Join Date
    Jun 2003
    Location
    United States
    Posts
    1,387
    Downloads
    0
    Uploads
    0

    Feedrate Override

    Hey, I am having problems with the override, it doesnt respond immediately and sometimes itll jump like 2x what I told it to go if I change during an arc.

    I have downloaded the hotfix for the homing problem and still having the problem with the feedrate override.
    Also, sometimes it saves my tool Z height and other times it doesnt.
    Do I have to save my offsets every time?

    Jon


  2. #2
    Registered
    Join Date
    Apr 2004
    Location
    United States
    Posts
    10
    Downloads
    0
    Uploads
    0
    from what i'v found, you cannot change feed override during an arc. if you do, it will still register that you hit the < key, but not show up on screen until the next step. if you hit it more than once it will jump 2x or more. same deal when on a straight line, it just shows up on the screen immediately and waits til next step to change speed. interesting how v3.1 didnt have this problem. also iv made it a habit never to jog z when i hit esc during an operation, because there it will not register that z moved, and will screw up your piece.
    good luck


  3. #3
    Gold Member
    Join Date
    Jun 2003
    Location
    United States
    Posts
    1,387
    Downloads
    0
    Uploads
    0
    I sent an e-mail to dakeng and he said that the feedrate over ride kicks in in the next line of code, He also said he plans on changing that back to how it was where it changes during the line.

    Jon


Similar Threads

  1. Spindle speeds and feedrate cap
    By HuFlungDung in forum OneCNC
    Replies: 11
    Last Post: 07-05-2005, 01:05 PM
  2. Feed Override
    By SCOJEN in forum DIY CNC Router Table Machines
    Replies: 0
    Last Post: 01-24-2005, 01:56 PM
  3. limit switch override
    By swarfmacdaddy in forum TurboCNC
    Replies: 5
    Last Post: 12-12-2004, 04:47 AM
  4. Maximum feedrate in aluminum with Proxxon MF 70
    By Christian in forum Knee Vertical Mills
    Replies: 2
    Last Post: 07-05-2004, 03:27 PM
  5. feedrate with DeskCNC
    By peterpan in forum Carken Products (Deskam, DeskCNC etc)
    Replies: 15
    Last Post: 05-29-2003, 09:24 AM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.