| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| TurboCNC Discuss TurboCNC controller software here! |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
08-26-2004, 11:13 PM
| ||||
| ||||
In case anyone is interested, the long awaited Version 4 is finally ready. http://www.dakeng.com
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)    |
|
#2
08-27-2004, 12:06 PM
| ||||
| ||||
| I just downloaded. Some good stuff has been added. I played around it from windows-dos, I like the look. Appears you can start program from a block or line in the program, the feed override goes up to 1000%. Built in editor. Function keys, Menu's and dialogue boxes. Lots more than I want to look at right now. I was hoping it would include tool radius comp (G41/G42), but it didn't happen yet. I see there are several more members to the programming team, so maybe updates will be more often. Bill |
|
#3
08-27-2004, 10:24 PM
| ||||
| ||||
| BIll, G41/G42 is supposed to be the next feature added, followed by constant velocity contouring or look-ahead. When those will happen is anyone's guess.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#5
09-01-2004, 02:16 PM
| ||||
| ||||
| I haven't seen this mentioned on the Yahoo group. You might want to post it there so they can look into it.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
| Sponsored Links |
| |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Deskcnc version that supports threading | Dan Mauch | Carken Products (Deskam, DeskCNC etc) | 1 | 04-04-2005 07:51 PM |
| VS3D version 1.5 released | dcarr | Virtual Sculptor VS3D / VScad3 Software | 0 | 02-15-2005 02:49 AM |
| Version 18 3D Question? | Konrad | BobCad-Cam | 8 | 01-05-2005 08:41 PM |
| VS3D version 1.33 released. | dcarr | Virtual Sculptor VS3D / VScad3 Software | 10 | 11-19-2004 05:37 PM |
| Mastercam Student Version on Amazon? | DmitryZ | Mastercam | 2 | 05-12-2004 09:23 AM |
| | |
Linear Mode
