Need help with Turbocnc!


Results 1 to 6 of 6

Thread: Need help with Turbocnc!

  1. #1
    Banned
    Join Date
    Mar 2003
    Posts
    109
    Downloads
    0
    Uploads
    0

    Default Need help with Turbocnc!

    Having a little trouble today.
    Trying to use tool offstes today, and once I set up all my tools, I then save them under the FILE section, the program will not run. So I checked the program, and it is now nothing more then ZERO's!
    Since I did save it ( the program)onto a floppy, I re-loaded it into "C", and tried it again, but I only saved the tool offsets, did not LOAD them, and then re-checked the program again, same results!
    What am I doing wrong, do I need to save each tool seperate from the others? I set all three at the same time, then saved them.
    Any help will save me any hair I might have left!
    Smitty

    Similar Threads:


  2. #2
    Registered balsaman's Avatar
    Join Date
    Mar 2003
    Location
    Canada
    Posts
    2139
    Downloads
    0
    Uploads
    0

    Default

    Hi,

    What version are you running? 3.22 is available on his yahou site files section. I know there was some sort of issue with 3.1a....

    Eric

    I wish it wouldn't crash.


  3. #3
    Banned
    Join Date
    Mar 2003
    Posts
    109
    Downloads
    0
    Uploads
    0

    Default

    Thanks Eric,
    I have 3.1a. I will see if I can find it on *****.
    Smitty



  4. #4
    Registered balsaman's Avatar
    Join Date
    Mar 2003
    Location
    Canada
    Posts
    2139
    Downloads
    0
    Uploads
    0

    Default

    Now you know why I misspelled yahou....

    Eric

    I wish it wouldn't crash.


  5. #5
    Banned
    Join Date
    Mar 2003
    Posts
    109
    Downloads
    0
    Uploads
    0

    Default

    I never even saw that!!
    Now I know what not to spell!
    Smitty



  6. #6
    Banned
    Join Date
    Mar 2003
    Posts
    109
    Downloads
    0
    Uploads
    0

    Default

    GOT IT!!!
    Yes, it was right in front of my eyes! I was actually trying to load the tool offsets from the Hard drive, that is why my program was all zeros.
    So, I did the next best thing, experiment. I finally tried the "F" key, which saves the position of the tool, and moved onto the next tool. Worked like it should.
    So, the learning curve continues.
    Eric, thanks for the help.
    Smitty



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Need help with Turbocnc!

Need help with Turbocnc!