| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| TurboCNC Discuss TurboCNC controller software here! |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#2
 
06-20-2007, 06:23 AM
| ||||
| ||||
| If you have not setup a tool table and saved it, there will not be one. This is useful if you have a standard list of tools (with length offsets) this can be handy. However if you are using say R8 tooling, the chances of having repeatability is nill. Bottom line, "not a problem" I have been running Turbocnc since ver 3.x and still don't have a tool file. If you want one, you will have to set it up and save it. See the documentation.
__________________ Art AKA Country Bubba (Older Than Dirt)  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Missing .DLL??? | CyborgCNC | Surfcam | 6 | 05-25-2007 12:41 PM |
| Am i missing anything here? | phantomcow2 | General Electronics Discussion | 7 | 08-11-2005 10:36 PM |
| Not sure what i'm missing? | Gnome | Gecko Drives | 3 | 03-27-2005 06:55 AM |
| Missing link | Konstantin | General Electronics Discussion | 2 | 03-07-2004 08:44 PM |
| AutoCad 2000 Missing .dll file | E-Stop | Autodesk Software (Autocad, Inventor etc) | 12 | 05-30-2003 11:43 AM |
| | |
Linear Mode
