| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| TurboCNC Discuss TurboCNC controller software here! |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
02-19-2007, 10:46 PM
| |||
| |||
I know directly that driving motors in phase mode withoun controller is possible in TurboCNC. May be someуbody know how to do it? My motors is unipolar, 0.5A. If I connect it with ising 4 wires of 6 (2 not used) it will be 3*4=12 pin lpt. How to connect a power supply so that the computer has not burned down?  |
|
#2
06-12-2007, 05:53 AM
| |||
| |||
look at this link .. not in english, but with pictures ... http://www.cnc.info.pl/topics46/turb...owe-vt3067.htm |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Can I convert single phase motor to three phase? | Jim Estes | Phase Converters and VFD | 30 | 01-24-2009 02:41 AM |
| Phase definition for SMC 800 controller | Magnar | TurboCNC | 5 | 04-04-2006 07:17 AM |
| 3-phase stepper controller | extreme | Open Source Controller Boards | 0 | 06-20-2005 10:03 AM |
| 3 phase transformer on single phase? | jevs | General Electronics Discussion | 4 | 03-19-2005 11:25 AM |
| | |
Linear Mode
