Help with Turbocnc - CNCzone.com-The Largest Machinist Community on the net!

aghobby · #1 02-21-2004, 09:20 AM

I`m trying to use the turbocnc program, i boot in dos, when i run the executable i get the message co-mathematic processor not found??

Anyone have an idea on this?

Thanks,
Alex

ger21 · #2 02-21-2004, 09:21 AM

Are you using a 386 processor? You need a 486DX or better.

Gerry

aghobby · #3 02-21-2004, 09:36 AM

I`m using Athlon XP2000.

Does i need a really old computer ro run this program??

balsaman · #4 02-21-2004, 11:15 AM

Hmmm...that is a good one...you may want to let Dave know. www.dakeng.com

E

fair451 · #5 07-10-2004, 09:44 AM

I had this very same issue with turbocnc using a 486DX running 100 megahertz. Plenty machine to run turbocnc. Same error message using my new laptop. Contacted Dave. He responded that his computer gave him the very same message.

I gathered that the solution is to ignore the message and move on.
Mike

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
turbocnc and cams gcode	Lu_ca	TurboCNC	1	07-12-2006 07:50 AM
Gibbs post for turboCNC?	gjahnke	GibbsCAM	9	03-09-2006 07:46 PM
Help setting up turbocnc 4.01..??	lurch	TurboCNC	4	05-07-2005 04:57 AM
TurboCNC and KCam3 a lost cause?	Davedbq	TurboCNC	17	04-27-2005 04:03 AM
Is it my computer or Turbocnc?	wjbzone	TurboCNC	11	04-10-2004 06:58 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)