| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| TurboCNC Discuss TurboCNC controller software here! |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
12-21-2003, 10:35 PM
| ||||
| ||||
I was useing Kcam4.0 to run my motors on a homebrew CNC table top carver/engraver -w- Stepper3 lll 3axis controller. For better preformance I was told I should try out TurboCNC. Well I thought I had the pinouts set correctly in the software , as well the axis configuration settings. Now all my motors whistle when I try to jog them? What did I do wrong? TIA Peace and Merry Christmas. Neil    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What encoders to use for these motors? | Cold Fusion | Servo Motors and Drives | 9 | 06-03-2005 12:14 AM |
| Does anyone know of a controller board for synchronized stepper motors | Yellowbeard | Stepper Motors and Drives | 2 | 04-04-2005 12:06 AM |
| Looking for controller board for synchronized stepper motors | Yellowbeard | General Electronics Discussion | 0 | 04-02-2005 09:50 AM |
| motors won't slow jog | gv71 | Gecko Drives | 9 | 11-04-2004 08:05 PM |
| Need help with staggering motors | viktorcnc | General Electronics Discussion | 0 | 07-05-2004 05:42 AM |
| | |
Linear Mode
