| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| TurboCNC Discuss TurboCNC controller software here! |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-19-2006, 03:56 PM
| |||
| |||
I was wondering how to get control of 4 5 6 7 8 axis if the pallerel ports pins are used up? can you use multiple port address while running a program to add more i/o commands and more axis control? Thanks for any help  |
|
#2
08-19-2006, 04:00 PM
| ||||
| ||||
| I think TCNC can use 3 parallel ports.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
