Cant figure this out.... Featurecam post processor

[Fixittt]

No matter what post processor I try....... I get weird took paths and code that Turbocnc doesnt understand. Anyone know of a Post processor for Featurecam?

[Bowman]

The HAAS post included comes close to being correct for TCNC but it does take a little manual editing. There are a few others that output close to TCNC but I have never come across a post made specifically for TCNC using FC. I have been wanting to take a crack at creating a post processor with the post builder in FC but then again I have been wanting to do a lot of things lol.. Good luck but I think the HAAS and maybe a BOSS post are closest.