| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| TurboCNC Discuss TurboCNC controller software here! |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
07-14-2006, 04:34 PM
| |||
| |||
Hi Anybody have any ideas on cutting pipe threads on Turbo? eddie  |
|
#2
07-14-2006, 08:16 PM
| ||||
| ||||
| Eddie, I don't think TurboCnc is setup for taper threads. Dave K may correct me on this one, but I think I have seen threads where this is not possible at this time. Dave, where are you?????
__________________ Art AKA Country Bubba (Older Than Dirt) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
