Backlash Question. V4.0.1

[BMaynard]

I have set backlash on all three axes. When TurboCNC reaches the end of its movement in a given direct it reverses the direct of the stepper motors. I presume it is now doing the backlash compensation. It however does this correction at a very high speed. Is it possible to slow this down?

[Bubba]

Backlash movement speed is hard coded and you will have to reprogram and recompile. If I remember correctly it is done at "max speed"

[dkowalcz]

Yes, Bubba is correct. This used to be done at the slowest speed, but folks complained about that too, so in the next release I plan to make the backlash comp speed configurable as well.

[BMaynard]

Thanks