I have a CNC Plasma table and I am trying to configure TCC for my machine. I think if I understand right, TCC can be set up for my own machine. Since I've had my Plasma table I've been using a couple of other programs to do my toolpaths and offsets, generating G-codes. Since I do my drawing in TC, I would like to do this in TCC so I don't have to save as DXF,open in another program, then toolpath, then send to the machine. Some times I do have to tweak the drawing a bit. This would be easier in TCC rather than swithing back and forth from program to pragram. I have read the TCC manual and watched the Turbocad Essentials Videos but just don't seem to be catching on. My plasma tables post procesor uses a couple G-codes not found in the TCC selection. I think they can be added but not sure how to set all of this up. Is anyone here willing and able to help with this. I know a little about G-codes(vey little) for I am self taught from running my table.If anyone would be willing to talk, I would like to talk about this. My typing skills are next to none and it takes me forever to communicate by typing. I am using TCC 11.2. Thanks tlf92