I am trying to find a replacement for the switch on a Tree 325 that locks/unlocks the tool in the spindle. It has a Normally Open module and a Normally closed module - for lack of a better name It is two position.
I dropped the switch used to engage the tool holder clamping mechanism. I was about to look up the number on the web but as I tried to wipe it off to get a better look... ALL the numbers wiped away...
Any ideas for a replacement? Or better yet what is the manufacturer and part number of the original?
Last edited by lavrgs; 07-06-2009 at 12:31 AM.
I am trying to find a replacement for the switch on a Tree 325 that locks/unlocks the tool in the spindle. It has a Normally Open module and a Normally closed module - for lack of a better name It is two position.
Are you looking for a Micro Switch? I try to attach a picture for you but not sure it come out OK or not, if not send me your E-mail address, I E-mail a sample picture to you
Ahn Vuong
Here is a picture of the item I need.There is one set of Normally open contacts and one set of Normally closed. There should be some springs that align to the posts shown in the second picture, where the grey and white parts should be spread apart by the springs. It mounts on a panel.