Need Help!- Tree 1050 Yansac mx3 TLO setting

[rbpower]

I need someone that can walk me through the basics of setting the tool length offset and a few other basic things to get my mill started up... I am more than willing to pay reasonable amount for over the phone help. PM me with your info and I will give you my # if you can help

controller is Yansac mx3

[maz43]

Call tool to offset from MDI. Go to offset page and put the cursor at the tool number you want to offset. Select handle jog mode. push measure button.
Measure button will light up. jog tool to touch off block. Hit write and return button. The offset will be entered , the tool will move back tool tool change position in z and the offset cursor will move to the next tool.
Repeat process for the rest of the tools.
There is a gage block setting via parameter. The offset screen should show the amount set (usually one inch). I don't know the parameter number but I can look it up tuesday when I go back to work.
Yasnac controls are kind of weird compared to modern fanuc controls.
Good luck.
PM me if you want more help.

Maz