Tree 2UVR

[mpoole]

Hello - I have a Tree 2UVR miling machine and I am trying to locate a M-1617 timing belt. This belt goes underneath the head and drives the spindle down feed. I would like to know who many teeth are on this belt. Thanks - mpoole

[TEntpeg]

Mpoople,

Just go to your friendly automotive supply store and get a v belt that will
fit. No cog teeth needed.

regards,
Jim

[jeep530]

if you are refering to the "timing belt" located in the bottom of the head housing it has 56 teeth on it the part no. is m-1616 it is located just above the belt marked part no. m-1617 in the parts book. 3s has these in stock and can fix you up.

[mpoole]

Thanks for your response. I have the M-1616 belt. The one I need has M-1617 stamped on it. The name in the parts manual is 9246 x 1/2" R3D1 Gilmer timing belt. It should have approx 50 teeth. I have tried 3S several times, the last time the number has been disconnected. Do you know of any other source?