Dynapath 20 axis card - CNCzone.com-The Largest Machinist Community on the net!

bassktcher · #1 11-17-2007, 08:26 AM

Hello. This is my first post but I have looked at this site a long time. I need a axis card for my dynapath 20 on my tree mill. Where would be the best place to get one at? When I am running the machine cutting a arc for instance, the y axis shuts down and the x keeps on going. So I reversed the y and z axis card just and now the z shuts down. It seems like I have a bad card. The machine shuts down on longer cycle times. My Tree is a very accurate machine but I need to get it fixed.
I enjoy the web site and thanks!!
Marty

ammach · #2 02-10-2008, 10:53 PM

I may have an extra one if its a Drive AXIS card. There are many sites that may have generic brands .Not sure how good THEY are though. Be careful. Will try to get some info for ya .

Tony

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Is it possible to run Dynapath 20 alone...	klysons	Tree	11	10-12-2010 05:29 PM
dynapath s10 help	diesel dave	General CNC (Mill and Lathe) Control Software (NC)	3	11-05-2007 05:11 PM
DIY 1-8 axis PC controller card	karl1	General Electronics Discussion	3	09-05-2007 12:39 PM
looking for a good place to get axis amp card	Nilad	Fadal	2	09-12-2006 12:23 PM
dynapath 40m z-axis problem	lynchee	General CNC (Mill and Lathe) Control Software (NC)	5	11-26-2005 09:30 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)