- Problem- J425 dynapath 20 z not referencing
-
Registered
J425 dynapath 20 z not referencing
When powering on the machine you can jog all the axis but when referencing X and Y will but Z does not. Z does not attempt to move when trying to reference. When I first got the machine it did the same thing but the problem went away by itself. Only fault the it show is Z needs to be reference. I am new to this machine so any help would be greatly appreciated.
Similar Threads:
-
-
Registered
Re: J425 dynapath 20 z not referencing
I would check probably a sticky limit switch.
- Problem- J425 dynapath 20 z not referencing
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules