Dyanpath 20 control

[Lesmark]

Any one drip feeding a dynapath 20 control? I'm using bobcad to send files via RS232....but now adays files are alot longer than 40 characters.....tryin to use th "RS232C" mode...but unable to get the correct parity???? Any help would be HELPFUL

Thanks Mark

[gm3211]

Mark,

On the Dynapath 20, there is Catalog Mode. I believe you type in RS232C, then in the Load Mode you select R option and P1 for parity on. Then move to Automode and cycle start...

You can not have any subprograms or repeat events.

If you need more help, give me a call in my office.

Greg Mercurio
Shop Floor Automations
www.cncnetworking.com
(619)461-4000