Tree Journeyman with Dynapath Control

[ARCHAEA]

Hi All,
Been out of CNC machining for a while now, looking to get back into it again slowly. Just bought a Tree J425 with Dynapath Delta 20 control. Powered up this weeked and was able to home and zero machine after a couple of day's playing with it.I mainly program in EIA GCodes and looking for help on how to use fixture offsets. Also, I seem to loose program position whenever I shut machine off. Anyone in the Columbus Ohio area with Dynapath control?

Similar Threads:

• New to Tree Journeyman 250 w/Dynapath Control
• Problem- Tree Journeyman 250 Dynapath 250
• Need Help!- Programming a Journeyman 250 w/Dynapath Delta 10M/20M Control
• Need Help!- Tree Journeyman 425 92-93 Dynapath 10m Motor Overload alarm
• Need a Laptop Cable for a Tree Journeyman 325 Dynapath

[underthetire]

You will loose position unless you use a fixture offset (E).

[ARCHAEA]

Underthetire, thanks for your response, it explains a lot. I will appreciate if anyone can post a simple Dynapath G Code program that uses a couple of (E) fixture offsets and has more than one tool. Thanks in advance all.