Tree 325 dynapath delta 20 drip feed

[85burban]

I was trying to drip feed a program and it faulted. So I looked at the fault
(021) radius issue. I went back to auto to see what line it stopped at and hit the reset button and the scrren went blank heard a clunk in the back of machine, and i had to turn off and refence machine and all programs and tool settings are gone WHAT WENT WRONG?

[jagardner4]

The problem is not related to drip feeding or the 021 error.

This is speculation on my part, but it sounds like pressing the Control Reset button caused a DC output to turn on (or off), which then caused a relay coil to turn on (or off). This action caused a short in the +24VDC and the entire power supply "crowbarred" or shut down. This is why the screen went blank.

The power supply would have reset when you cycled power on the machine, but one of the side effects of the sudden shutdown was apparently to lose part program memory and tool offsets. This may indicate a bad backup battery.

I think you need to find what is shorting out when you press the Control Reset button. You could start by connecting a meter to the +24VDC and recreating the problem to verify that the +24VDC is indeed going to 0VDC.

[85burban]

Originally Posted by jagardner4 The problem is not related to drip feeding or the 021 error. This is speculation on my part, but it sounds like pressing the Control Reset button caused a DC output to turn on (or off), which then caused a relay coil to turn on (or off). This action caused a short in the +24VDC and the entire power supply "crowbarred" or shut down. This is why the screen went blank. The power supply would have reset when you cycled power on the machine, but one of the side effects of the sudden shutdown was apparently to lose part program memory and tool offsets. This may indicate a bad backup battery. I think you need to find what is shorting out when you press the Control Reset button. You could start by connecting a meter to the +24VDC and recreating the problem to verify that the +24VDC is indeed going to 0VDC.

I got the thing to drip feed and figuered out the problem why it kicked all of my memory out. The information that ive read and seen on all forums is somewhat confusing to a person that is new to cnc. The good thing is that now I have experienced the whole thing first hand I can walk anybody through that process again. Thank you for helping me.