Tree VMC 1060 on overlimit sw error - CNCzone.com-The Largest Machinist Community on the net!

wildwhl · #1 09-21-2011, 11:42 AM

Please read here - post 8:

http://www.cnczone.com/forums/tree/1...tml#post996051

Thanks!

WW

wildwhl · #2 09-24-2011, 07:47 PM

Solution - had to *tap* the axis off the limit. Couldn't find any way of manually moving it, and fault/reset/etc. held down did not activate the servo drives.

WW

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Going to leap from X2...to Tree VMC 1060 - advice!	wildwhl	Benchtop Machines	2	06-26-2011 10:13 AM
Need Help!- Tree 330 with error codes	ktmrider	Tree	2	08-18-2010 10:37 AM
Tree VMC 1060	StahlMachine	Tree	2	12-27-2007 08:55 AM
Zps Tree Vmc 1060 Way Cover	envisioneng	Tree	1	07-25-2007 11:33 AM
num 1060 or the like	sc_crasher	Fanuc	3	01-11-2006 07:11 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)