J-325 Delta 20

[red zilla]

I was running my tree j 325 the other day with a .125 endmill and was almost done with a 600 line program when the end mill broke when it was on line 530
so I put a new end mill in and set my z zero but I couldn't figure out how to get the mill to start back on line 530 of the program in auto mode, can someone tell me how to start on any line in auto mode? or is it even possible?
Thanks

[jagardner4]

Do what's called a sequence number search.

In either Program or Program Display mode (mode 3 or 4, respectively), press 'N', then the sequence number you want, then 'Enter.' That sequence number event will now appear on the screen in the Program mode or move to the top of the screen in the Program Display mode. Now go back to the Auto mode (mode 1) by pressing 'Mode Select', then '1.' The sequence number you've selected should now appear in the 'Next N' field (if your control is new enough to have that field on the Auto screen.)

Press Cycle Start to begin execution at that event.

By the way, pressing 'Control Reset' at any time (when your out of cycle) will take you back to the start of the part program.

[red zilla]

thanks jagardner I will give it a try today.