DNC for drip feed - CNCzone.com-The Largest Machinist Community on the net!

ramsey321 · #1 10-15-2010, 06:57 PM

Can anyone tell me if there is free DNC software that I can load on my PC to drip feed large programs to my J325 tree mill. Is there anyone out there that has drip feed to their J325 and if so what do you use. I have a Dynapath Delta 20 controller. Thanks

underthetire · #2 10-15-2010, 07:24 PM

yes, and any program should work. I used to just use windows terminal. In the catalog page you type in RS232C, that starts a drip feed set up.

ramsey321 · #3 10-16-2010, 07:16 AM

Underthetire, can you please elaberate on this. I am not sure what you mean. Are you saying you use a windows program already on your pc or did you purchase this program. Thanks

Fastest1 · #4 10-16-2010, 07:34 AM

Yes it is called "Hyperterminal" I think. I have never used it but in pursuit of a dnc transfer solution I did read about it.

jagardner4 · #5 10-16-2010, 11:43 AM

There is a document online at the DynaPath website that describes how to use Hyperterminal to communicate with a DynaPath CNC:

http://www.dynapath.com/HyperTerminal.pdf

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Drip feed or DNC	airlid	Mori Mills	2	02-17-2010 05:19 PM
Need Help!- drip feed	kirby	Fanuc	29	11-28-2009 08:04 PM
Need Help!- Drip feed on/off	sve0019	Mazak, Mitsubishi, Mazatrol	3	09-14-2009 11:14 AM
Drip feed?	MrWild	Dolphin CADCAM	1	02-24-2008 10:33 PM
Drip Feed	camtd	Surfcam	0	07-31-2006 06:09 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)