Results 1 to 2 of 2

Thread: Tree 1050 VMC programming

  1. #1
    Registered
    Join Date
    Jul 2010
    Location
    United States
    Posts
    6
    Downloads
    0
    Uploads
    0

    Tree 1050 VMC programming

    what would be the correct RS232 settings on my computer to get the program into the machine?

    thanks


  2. #2
    Registered maz43's Avatar
    Join Date
    May 2009
    Location
    USA
    Posts
    100
    Downloads
    0
    Uploads
    0
    This works on the Tree 1050 I run. The control is Yasnac MX3.
    The machine end cable jumpers pin 4-5 and pin 6-8-20.

    BAUD-4800
    DATA BITS-7
    PARITY-EVEN
    STOP BITS-1
    ASCII/ISO
    HANDSHAKE-XON XOFF
    ENABLE DTR
    ENABLE RTS


    Good luck


Similar Threads

  1. Need Help!- Tree 1050 spindle drive??
    By leeyoung in forum Tree
    Replies: 10
    Last Post: 02-16-2011, 02:32 PM
  2. New to Tree 1050 zps VMC
    By maz43 in forum Tree
    Replies: 1
    Last Post: 06-03-2009, 02:32 PM
  3. Need Help!- Tree 1050 Yansac mx3 TLO setting
    By rbpower in forum Tree
    Replies: 1
    Last Post: 05-22-2009, 06:19 PM
  4. Replies: 3
    Last Post: 11-18-2007, 03:47 PM
  5. 1050 tree zps vmc
    By Treeves in forum Tree
    Replies: 0
    Last Post: 08-30-2006, 07:13 AM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.